A Gatewood company - serving Sunrise Manor, NV

Ghost Controls Gate Motor & Opener in Sunrise Manor, NV

Wrought ironWrought iron
Wood & steel frameWood & steel frame
Farm & ranchFarm & ranch
Sliding driveway gatesSliding driveway gates
LiftMaster operatorsLiftMaster operators
Every visit starts with

Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted

The assessment is free and the quote is the invoice.

Get your free estimate

Ghost Controls Gate Motor & Opener in Sunrise Manor: What to Know First

Ghost Controls gate motor and opener repair in Sunrise Manor typically runs $210 to $480 for a motor, control board, or arm replacement, and most diagnostic visits get the gate cycling again the same day. Solar and battery-backup systems are the most common call we get in this ZIP. We quote the price before we touch a bolt, and the number on the estimate is the number on the invoice.

Call (844) 761-8729

This page is for the homeowner who already has a Ghost Controls arm on the gate – the DIY-style system sold for driveway and rural gates – and needs it diagnosed, serviced, or swapped without guessing. If you are anywhere in Sunrise Manor, call (844) 761-8729 and a live person picks up, day or night. We service Ghost Controls as an independent Ghost Controls service provider; we are not affiliated with or authorized by the manufacturer.

How Ghost Controls Products Fail – and How We Fix Them

Ghost Controls builds a genuine workhorse for single and dual swing gates. The failures we see in Sunrise Manor aren’t brand defects. They’re wear points that show up in a specific order, and knowing the order saves you money.

  • Solar and battery backup failing first (AXL and TSS series). Owners call saying the gate “worked all summer, then quit in fall.” The arm isn’t dead; the battery is. On solar units the panel charges a sealed battery that simply ages out, and short winter daylight pushes it over the edge. We load-test the battery and panel output before we ever price a motor.
  • Control board and receiver dropping the remote. The LiftMaster-style receiver logic in the ARD and TSS boards is reliable until moisture gets into the enclosure. In Sunrise Manor, a control box mounted in full afternoon sun with a loose lid seal collects dust and then condensation. We reseal the enclosure and replace the receiver module, not the whole board, when only the receiver is gone.
  • Operator arm binding at the hinge. A Ghost Controls arm pushes a gate on a hinge that has sagged. If the gate drags, the arm keeps shoving and the gearbox eats itself. We check the hinge post and gate swing before blaming the motor – a gate binds at the post, not in the middle of the panel.
  • Limit and stroke adjustments drifting out of spec. The arm has to hit its open and closed limits cleanly. Over time the arm slips or the mount loosens, and the gate stops mid-travel. We reset stroke and travel limits and torque the bracket so it stays.
  • Obstruction-safety and entrapment sensitivity. The reversing sensor on a Ghost Controls arm can get fooled by a worn hinge or a binding gate and refuse to close. We tune the force and sensitivity to the actual gate, then test the reverse on a real obstacle – a person’s weight, not a hand push.

Two things an owner won’t find on the manufacturer’s site: the solar battery on an AXL series unit usually outlasts its rated lifespan by a year or two in our heat, then fails without warning in the first cold snap – so we test it annually rather than wait for the call. And a TSS-series gate that stops closing on its own is almost always reading a binding hinge as an obstruction, not a bad sensor. Fix the hinge, stop chasing the board.

Explore

Styles & brands we work with

  • Wrought iron
  • Wood & steel frame
  • Farm & ranch
  • Sliding driveway gates
  • LiftMaster operators

Our Ghost Controls Gate Motor & Opener Process

  1. 1
    Call and a real conversation. A live person answers, and we ask what the gate does and doesn’t do. No diagnosis over the phone, but we come out knowing what to look for.
  2. 2
    On-site diagnostic. We test power, battery, solar output, limits, and swing resistance in that order. We find the actual cause instead of swapping parts.
  3. 3
    Parts decision, explained. If an OEM Ghost Controls part is available and warranty-safe, we use it. When a quality aftermarket gearbox or battery does the job for less, we tell you the trade-off and let you choose.
  4. 4
    The repair. Arm replacement, control board, battery, receiver, or a hinge repair that keeps the original motor alive. Welding, if the mount needs it, happens in your driveway.
  5. 5
    The test. Gate opens, closes, reverses on an obstruction, and runs a full cycle on battery backup. We watch it run twice before we call it done.
  6. 6
    The promise in writing. The 90-Day Done Right Promise is stamped on the job. One call brings us back, no runaround.

What Ghost Controls Gate Motor & Opener Costs in Sunrise Manor

These are the ranges we quote in Sunrise Manor. Your written estimate may land inside or below them depending on the gate.

Job Typical range
Diagnostic and adjustment $95 – $150
Battery or solar panel replacement $140 – $260
Receiver or control board replacement $210 – $360
Operator arm replacement (single) $320 – $480
Hinge and mount repair $180 – $300
Full single-swing operator install $1,100 – $1,800

What moves the price: single vs. dual arms, solar vs. hardwired power, whether the mount needs welding, and OEM vs. quality aftermarket parts. The estimate is quoted and agreed before any work starts. Call (844) 761-8729 for a free estimate – and ask about $40 off any repair over $200, no trip charge inside the county, a free second opinion on any written estimate, and 10% off for seniors and veterans.

Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Why Sunrise Manor Homeowners Call Gatewood Fence & Gate Sunrise Manor for Ghost Controls Work

We’re locally owned and owner-operated, with a published address and license number anyone can look up. Calls are answered by a live person, 24/7 – not voicemail, not a queue three states away. Our technicians have up to 25 years of experience and are background-checked and uniformed on every job. We’re certified to service nine major brands, so if a Ghost Controls part is back-ordered we can point you to a LiftMaster, Mighty Mule, or DoorKing equivalent that fits the same gate and tell you the trade-off straight. Every job carries the 90-Day Done Right Promise in writing. The name is on the shop, and the shop is down the road – that’s the oldest accountability there is.

FAQs

Contact Gatewood Fence & Gate Sunrise Manor

If your Ghost Controls gate is stuck, dragging, or quitting in the cold, call (844) 761-8729 for a free estimate. A live person answers 24/7, we quote before we start, and the 90-Day Done Right Promise comes stamped in writing on every job. We’re proudly serving local communities for over 29 years – owner-operated since 2001, with the name on the shop and the shop down the road.

Written by the team at Gatewood Fence & Gate Sunrise Manor, serving Sunrise Manor and nearby areas.

Need Gate Repair help nationwide? Licensed & insured · same-day response · free estimates
Call (844) 761-8729
Local Service Coverage

Request a Free Estimate in Sunrise Manor

Tell us what you need - Gatewood Fence & Gate Sunrise Manor responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Text Now
Call Now - 24/7 Dispatch