Wood & steel frame
Wrought iron
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateTrusted Gate Installation for Sunrise Manor Homeowners
Most gate problems in Sunrise Manor aren’t really about the gate. They’re about a hinge post set in caliche that a crew didn’t dig deep enough for, or a driveway slope off Las Vegas Boulevard North that sends the gate swinging back open by itself. A gate has to work with the ground under it, and the desert ground here is unforgiving. That’s the part we check first. Our technicians have up to 25 years of experience, and the person who measures your gate is the person who answers your call when it’s finished. We quote a price and agree on it before any work starts, and every job carries the 90-Day Done Right Promise in writing. Call (844) 761-8729 and we’ll come out for a free estimate.

What Our Gate Installation Service Includes
Every gate we install gets measured on site, not off a fence line on a survey. The six setups below cover nearly everything homeowners in Sunrise Manor ask us about.
Driveway Gate
A driveway gate is the gate you use every day, so it takes the most abuse. You need a new one when the old gate is too narrow for a second vehicle, when the posts are leaning in the wind, or when you’re adding a gate where there never was one. We set posts to depth for our soil, hang the gate to clear the drive, and leave you with a gate that opens and closes the same way every time. If the gate is going to be automated later, we’ll tell you now what to put in the ground so you aren’t digging twice.

Pedestrian Gate
Pedestrian gates are the walk-through gate next to the driveway or the one at the side of the house. They’re needed when the old gate has dragged its latch for years, when the yard needs a clean walk-in entrance that isn’t the main driveway, or when you want a gate you can lock. We hang these so the latch meets cleanly the first time, which is mostly about the post. A pedestrian gate that sags once will keep sagging until the post is fixed.

Sliding Gate
A sliding gate rolls along a track instead of swinging out, which makes it a good fit for a sloped drive or a short setback. You want one when there’s no room for a swing, when a swinging gate would catch the wind off the desert, or when you want a wider clear opening than a swing gate gives you. We set the track on a proper footing so the gate doesn’t ride up over the years, and we set the rollers so the gate meets its stop square.

Swing Gate
A swing gate is the classic single gate, hinged on one side and swinging into or out of your property. You need one when you want a traditional look, when your drive is reasonably flat, and when the hinge side has good solid ground for a post. We check the swing path and the ground first. A gate that swings open into a slope or a parked truck is a gate that gets broken in a hurry. Swing gates are also the easiest to automate later, which is worth thinking about now.
Double Gate
A double gate is two leaves meeting in the middle, used for wide driveways, RV pads, and equipment access. You want a double gate when the opening is wider than a single leaf can carry without sagging, or when you need the full width for a trailer or a boat. The catch with doubles is the meeting point. We set both posts off one string line so the two leaves meet flat at the center, which is the part most quick installs get wrong.
Security Gate
A security gate is a gate built for keeping people out, not just for looks. You need one when the property line faces an alley, when the yard has been walked into before, or when you want controlled entry instead of an open drive. We build these heavier at the frame and hinges, because a security gate that sags in a year isn’t doing its job. If you want an operator, a keypad, or a call box on it, we can set the gate now so the access gear goes on later without rework.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Brands We Service for Gate Installation
Automation is where most gate jobs live or die, so it’s worth knowing the names. We service LiftMaster gate operators and know how their limits and reversing sensors behave after a couple of Las Vegas summers. We also work on FAAC arms and operators, which show up a lot on sliding gates, and we know where the wear shows up first on the gear and the arm. Linear operators are common on residential swing gates here, and we know their control boards well enough to tell you when a repair makes sense and when it doesn’t.
It helps to hear the gate run before we recommend anything. A gate that’s fighting a bad post will wear out an operator no matter which brand is on it, so we check the gate first and the motor second. Whether you have LiftMaster, FAAC, or any other make, we can help.

Signs You Need Gate Installation Right Now
- The gate drags on the ground when it swings. When a gate scrapes the concrete or the dirt, the hinge post has started to move. That’s a post problem, not a gate problem, and leaving it means the gate and the operator both wear out faster.
- The latch won’t line up anymore. A latch that used to close and now needs a shoulder tells you the gate has dropped or the post has shifted. Fixing the latch itself buys you a few months at most.
- The posts lean or the concrete around them is cracked and lifting. Desert soil and summer heat move concrete over time, and a post set shallow will work loose. A gate on a loose post is a gate waiting to fall on someone.
- The gate is too narrow or the opening doesn’t fit how you use the drive now. A new truck, an RV, or a second vehicle doesn’t fit the gate that was there in 2004. Widening the opening properly means resetting posts, not bending the gate.
- You’re adding automation and the gate isn’t built for it. An operator on a light gate with a tired frame will bind, reverse, and strain the motor. If you’re planning to automate, the gate and posts need to be right first.
Our Gate Installation Process – Step by Step
- 1
We come out and look at the ground, not just the gate. We walk the opening, check the slope, and dig a small test to see what the soil is doing. In Sunrise Manor that matters more than the gate catalog, because caliche and hardpan change how deep a post has to go.
- 2
We measure, and we quote in writing. You get a written estimate with the gate, the posts, the hardware, and the labor broken out. The price we quote is the price you agree to before any work starts. No surprises at the door.
- 3
We set the posts and let the concrete cure. Posts go to the right depth for the gate weight and the ground, and we don’t hang a gate on green concrete. That’s a step some crews skip, and it’s why their gates lean within two years. We’d rather lose a day than redo the job.
- 4
We build and hang the gate on site. Most of our gates are built and welded on site, which means the gate is built to your opening and not to a factory tolerance. We check swing, latch, and clearance by hand before we call it done.
- 5
We walk it with you and hand over the promise in writing. You open and close it yourself while we’re standing there. If anything isn’t right, we fix it before we leave, and the 90-Day Done Right Promise is on paper in your hand. One call brings us back.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Gate Installation Cost in Sunrise Manor?
Gate installation in Sunrise Manor generally runs from about $1,400 for a basic pedestrian gate up to $7,500 or more for a wide double driveway gate with heavier framing and posts. The number moves with the width of the opening, the gate material, how deep the posts have to go, and whether the site needs concrete removal first. A typical pedestrian gate runs $1,400 to $2,600 installed. A single driveway swing gate is usually $2,400 to $4,200. A sliding gate runs $2,800 to $5,500 depending on track length and footing. A double gate is usually $3,800 to $7,500. Adding an operator, keypad, or access control is a separate line, and we quote it separately so you can see exactly what you’re paying for. Call (844) 761-8729 for an exact quote. Estimates are free, there’s no trip charge inside the county, and the price is agreed before anyone picks up a shovel.
Gate Installation Near Sunrise Manor – Our Service Area
Sunrise Manor sits on the east side of the valley, and we work the neighborhoods around it all week. If you’re in Whitney or Winchester we’re usually out there within the day for an estimate, and we cover North Las Vegas, Paradise, Henderson, Las Vegas, Spring Valley, Enterprise, Summerlin, Boulder City, and Sandy Valley as well. If you’re just looking at what a new gate would cost, start with our page on Gate Installation in Sunrise Manor and we’ll take it from there.
Serving Sunrise Manor, NV – Our Local Coverage Area
We serve Sunrise Manor and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Gate Installation in Sunrise Manor
Gate installation is the process of setting new posts, building or fitting a gate to the opening, and hanging it so it opens, closes, and latches correctly. It covers everything from a small pedestrian gate to a wide automated driveway gate. In Sunrise Manor the ground conditions make the post work the most important part, since a shallow post will sink or lean within a couple of summers. We measure on site and quote before any work begins.
A pedestrian gate is usually done in a day, and a single driveway gate takes about one to two days once the posts have cured. Sliding and double gates with concrete footings can run two to three days, mostly because the concrete has to set before the gate goes on. We give you the schedule up front and tell you when we’ll be back. This is measured, ordered, and scheduled work, not a same-day repair, so we’ll book it properly.
Most gate installations in Sunrise Manor land between $1,400 and $7,500, with a typical single driveway gate around $2,400 to $4,200. The final number depends on the opening width, the material, the post depth, and whether you’re adding access control. We quote in writing and agree on the price before we start, and we never change it at the door. Call (844) 761-8729 for an exact quote, estimates are free.
Yes, we service LiftMaster, FAAC, BFT, Linear, and any other make of gate operator you have. We check the gate itself first, since an operator on a bad post will keep failing no matter the brand. Whether the gate needs a new install or the operator needs service, we can help. Call and we’ll talk it through.
Yes, a live person answers the phone 24 hours a day, so if a gate is stuck open or a post has given way you can call and get a real answer. Emergency work is repair, not new installation, since a new gate is measured and scheduled. For installation questions, call during the day and we’ll set up a free estimate. Either way, (844) 761-8729 gets you a person.
Every job carries the 90-Day Done Right Promise, in writing. If something we installed isn’t right, one call brings us back and we make it right, no runaround. It’s printed on the job, not buried in fine print. Call us and we’ll be glad to walk you through exactly what it covers.
Clear the driveway and the area around the opening before we arrive, and move vehicles so we have room to set posts and swing the gate. If there’s an old gate coming out, we can handle removal, but let us know when you book so we schedule the time. If you have an HOA, check the gate style rules before we measure, and we’ll work with what they allow. Call (844) 761-8729 and we’ll tell you exactly what to have ready.
Schedule Your Gate Installation Service in Sunrise Manor Today
If your gate is leaning, dragging, or you’re ready for a new one, call (844) 761-8729. A live person answers, day or night, and we’ll set up a free estimate for your Sunrise Manor property. You get a written price before any work starts and the 90-Day Done Right Promise on paper when it’s done. No obligation, no pressure. You can also see our Gate Installation in Whitney and Gate Installation in Winchester pages, or start at home to see everything we do.
Written by the team at Gatewood Fence & Gate Sunrise Manor.