Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGhost Controls Gate Motor Replacement: The Sunrise Manor Owner’s Guide
We replace failed Ghost Controls gate motors in Sunrise Manor, and a straight swap of the motor and control box usually lands between $475 and $725 installed, depending on model and whether the arm and board come as a kit. Because motor replacements are on the truck and ready to go, most Sunrise Manor jobs are handled the same day you call. Springs, codes, and board logic are the usual suspects. The symptom picture is familiar: the gate runs a foot and stalls, reverses for no reason, clicks but won’t move, or trips the breaker every time it tries to cycle.
Which Ghost Controls Models This Applies To
Ghost Controls builds its systems as matched kits, and a replacement motor is only as good as the box it’s paired with. The single-arm kits (AR, AS, and DTP lines) use different arm lengths and pin positions than the dual-arm and heavy-duty systems, so the first thing we do is read the label inside the control box – not on the arm – to confirm the exact model. On a Sunrise Manor property where an older kit has been repainted or the sticker faded, we measure the arm length and count the limit-switch positions instead. Between an OEM Ghost Controls board and a quality aftermarket equivalent, most Sunrise Manor owners are better served by OEM on the control board (the firmware and code logic are matched to the remote) and by a factory-spec aftermarket on the arm itself, where the geometry is simpler and the price can drop by a hundred dollars or more. We’ll lay both options out before anything is ordered.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Signs Your Ghost Controls Gate Motor Replacement Is Failing
These are the five failure patterns we see most often on Ghost Controls systems around Sunrise Manor, and what’s usually behind each one.
- The gate runs a foot and stalls. That’s almost always a worn or slipping drive gear inside the motor housing, not a board problem – the board is still sending power, but the gear can’t finish the turn.
- The gate reverses mid-travel for no reason. Ghost Controls boards use onboard sensors rather than external safety edges, and when those sensors or their wiring degrade, the board interprets resistance as an obstruction and backs off. Sometimes it’s a dirty gate track; more often it’s a failing board.
- You hear a click but the arm doesn’t move. Classic sign of a burned motor winding or a failed capacitor – the board fires, but the motor can’t turn. On older Ghost Controls units this is a motor-and-board job, not a motor-only job.
- The breaker trips every time it cycles. That’s a short in the motor wiring or the low-voltage harness. It’s also the one symptom we tell people to stop pushing – a tripping breaker is a fire risk and deserves a call, not a reset.
- The remote works, then stops, then works again. Often not the motor at all. A weak battery in the remote, a bad receiver, or a code collision with a neighbor’s system will all mimic motor failure. We test the receiver before quoting a motor.
Replacement Cost & What’s Included
Sunrise Manor pricing for a Ghost Controls motor replacement runs roughly $475 to $725 installed, and here’s what moves that number.
- Motor and control box only: the low end of the range, typically $475 to $575, when the arm, brackets, and wiring are sound and only the motor housing and board are swapped.
- Motor plus arm assembly: $575 to $675 for the AR, AS, and DTP single-arm kits where the drive gear and arm are replaced together.
- Dual-arm and heavy-duty systems: $650 to $725 and up, since there’s twice the hardware and double the alignment work.
- What’s included: the part, installation, alignment, limit-switch setup, remote re-pairing, and a full test cycle before we leave.
The price you’re quoted is the price you pay – we walk the numbers with you before we start, not after. Every motor replacement carries the 90-Day Done Right Promise in writing, and that includes a call-back if the new motor misbehaves in the first ninety days. $40 off applies to any repair over $200, so a typical Sunrise Manor motor swap gets the discount automatically.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
There are a few things an owner can safely do. Check the breaker and confirm it’s not tripping. Read the model label and write it down. Test the remote with fresh batteries. Cycle the gate by hand with the arm disconnected to see whether it’s binding or free – that single test tells us more than an hour of phone diagnosis.
Where DIY goes wrong is at the box itself. Ghost Controls control boxes hold 12-volt DC on the low side and 120-volt AC on the high side, and the transformer sits right next to the board you’d be reaching into. We’ve been called out to more than one Sunrise Manor gate where a blown transformer was the real problem and a homeowner had already ordered a motor. If the breaker is tripping or you’re seeing scorch marks, stop and call. The rest can wait for a professional. Call (844) 761-8729 for a free estimate and we’ll tell you honestly what you’re looking at.
FAQs
Expect eight to twelve years on a well-installed system in this climate, but Sunrise Manor’s summer heat is the real variable – motors that run in direct afternoon sun through July and August typically wear out closer to the eight-year mark. UV exposure bakes the housing seals and speeds up gear wear. Shade and regular limit-switch adjustment push the number toward the top of the range.
Sometimes, yes. If the issue is a slipping drive gear, a bad limit switch, or a single failed capacitor, we can often repair the existing unit for a fraction of replacement cost. If the winding is burned or the board has lost its sensor calibration, replacement is the honest answer. We’ll give you both prices before you decide, and we always repair first when the parts allow.
Two to three hours for a single-arm Ghost Controls system, and three to four for a dual-arm or heavy-duty unit. On a Sunrise Manor job, the arm alignment and limit-switch setup are usually the longest steps because a gate that was hanging off-level will fight the new motor until we correct it – and we do. We don’t hand you a gate that’s going to grind against its own hardware in six months.
Ghost Controls parts come from factory-authorized supply channels, matched to the model number on your control box – not a generic retrofit. We confirm the model before ordering, and we don’t install a motor that wasn’t built for your specific kit. If a factory part is back-ordered, we’ll tell you the timeline honestly and let you decide whether to wait or go with a factory-spec equivalent.
Gatewood Fence & Gate Sunrise Manor: A Name You Can Look Up
Gatewood Fence & Gate has been locally owned and owner-operated since 2001, and the name is on the shop. We handle Ghost Controls, LiftMaster, Mighty Mule, DoorKing, and five other major brands, and we’re certified to service all nine. Our technicians have up to 25 years of experience, and we’re upfront about something important: we’re an independent service provider – not affiliated with Ghost Controls itself. A live person answers the phone 24 hours a day, and there’s no trip charge inside the county. Seniors and veterans get a permanent 10% discount, and we’ll give you a free second opinion on any written estimate you’ve already got. Call (844) 761-8729 for a free estimate on your Ghost Controls gate motor replacement in Sunrise Manor – we’ll show up in the window we promised, and the price on the phone is the price on the invoice.
Written by the team at Gatewood Fence & Gate Sunrise Manor, serving Sunrise Manor and nearby areas.